Precautions in the manufacturing process of aluminum alloy forged ring

Aluminum alloy forging ring is a product produced in the forging industry, and it is also a type of exercise. It is a metal material that, under the pressure of external forces, becomes a very suitable compression force ring through the requirements of molding deformation. This force is typically achieved through the use of a hammer or pressure.

The manufacturing process of aluminum alloy forged rings creates a fine granular structure and also improves the physical properties of the metal. Ring forgings can be seen everywhere in daily life, and it is a typical industrial product. The application of aluminum alloy forged rings is very wide, and every industry can be used. When producing aluminum alloy forged rings, it must be noted that you can not directly use your hands or feet to clean the oxide skin on the anvil surface.

Because when the oxide is blown with compressed air, no one can stand on the opposite side. Before the hammer has stopped, remember not to put your body or any part under the fist to take, or to put tools or work. When the mold is replaced or the hammer is stuck, and the forging is stuck on the broken film, the power source should be cut off immediately, and the work can be carried out after the support at home.

Do not overburn or lower than the final forging temperature of the ingredients, so as not to break and fly out, hurt people, causing unnecessary damage. And can not put hot forgings or tools on the channel above, do not pay attention to it will cause security risks. Aluminum alloy springs should be placed in its specific location, and can not be stacked too high. Before the start of work, you must wear the prescribed protective equipment, and be sure to follow the code to the leaflet.

Before starting to work, carefully check the relevant mechanical and electrical equipment, molds, tools, auxiliary facilities and hydraulic pipelines, are not all safe and reliable, the store should add lubricating oil to the equipment, if you do not do these preparatory work, then you can not directly start to work and use. Before working in the forging plant, you should preheat all the tools you use, such as hammerheads, hammerrods, molds and tools.

In the process of work, it is not possible to throw raw materials at a distance, and some protective baffles should be added to throw away at close range. Aluminum alloy forged ring ingredients can not be thrown from the sidewalk, for some large ring broken wire, must be clamped with pliers, and to be transported by the crane.